Make the Butterfly Bracelet

This project is for a 7 1/2 " bracelet (including clasp and toggle).  Make any adjustment to length by eliminating or adding Butterfly Wing components.   Start by attaching the ring of your toggle clasp to a piece (long enough for the length of your bracelet) of Soft Flex beading wire and crimping the end using a crimp bead.  Cut off any excess bead wire and begin stringing one of each of the following in this order: 2mm Gold filled round bead, 4mm beaded bead cap, 4mm Swarovski bicone crystal bead and Butterfly Wing.  Continue with the same order until you have achieved the desired length, then add a 4mm Swarovski crystal bicone, a 4mm beaded bead cap and a 2mm Gold filled round, taking into account the toggle bar that you will need to attach and secure with another crimp bead.  Trim away any excess bead wire.   This project is brought to you by TierraCast ®

 To create the 7 1/2" design above you will need the following items

(this beading project assumes you already have pliers - if not, see our tools section)